AVBIAviation Bus
Interface
Launch enquiries
Overview/Applications
Bench applications

On the test bench

Bench setups for investigating a reported fault, checking a navigation receiver and tracing an intermittent signal.

Fault reproduction

Reproduce a fault from a shared log

A developer reports a display dropout and sends the recording from the run. Copy the compatible AVBI log to the microSD card, preview its contents and select the output wired to your receiver.

Start at the original timing to reproduce the sequence. Slow playback to follow the display, then run the same file again after a fix.

See Replay Log
The ARINC 429 replay screen with receiver-check.csv selected, transmit channel TX0 and original timing.
ARINC 429 replay with an example recording selected on TX0.
Signal diagnosis

Find out why a position became invalid

A display loses latitude while ground speed still looks plausible. Use live decode to see whether latitude carries a failure warning, then open the raw monitor to inspect the received word.

Record the relevant channels for the next run. The timestamped log gives a colleague the sequence that led to the fault.

See the failed latitude example
Live decode table showing BAD SSM for Latitude, valid Longitude and valid Ground Speed.
Example inputs on RX0. Longitude reads 11.250000 E and Ground Speed reads 142.5 kt.

Have a different test in mind?

Share the interface, stimulus and response your bench needs.

Discuss a use case